C
Copyright Technolog Ltd. 2017. All rights reserved.
Information contained in this document subject to
change without prior notice.
Sheet 7 of 43
Technolog Limited,
Ravenstor Road,
Wirksworth,
DE4 4FY,
United Kingdom
T: +44 (0) 1629 823611
E: techsupport@technolog.com
www.technolog.com
DMR No.: 7504
2099PM9000 Rev. B
Typical installation: Moulded wall bracket
(p / no. 2099TT6400)
Notes
In order to maximise the remote communications signal strength, the unit should be positioned as
high up as possible and, where practical, away from metal structures.
However the unit should also be positioned such that exposure of users and / or bystanders to the
potentially dangerous radio frequencies ('RF') generated by the equipment are kept below
recommended levels - for further details refer to Technolog Declaration of Conformity ('D of C')
document 2099DC9000 associated with the Cello 4S, as well as the "RF exposure
considerations" part of the "Standard connections - Port 5: External antenna connection" section
of this document.
•
•
Step 2b
Clip the lid of the
unit in the bracket
Step 1
Drill two holes in the positions indicated to
take 'Rawl' plugs suitable for 1 1/2" x 8mm
(or equivalent) screws
Step 2a
With the label on
the front of the
unit facing away
from the bracket,
locate the rear
mounting leg in
the bracket
4
6
m
m
m
in
.
5
8
m
m
c
e
n
tr
e
s
