GETTING STARTED WITH TS-ENC720
RUGGED METAL ENCLOSURE
1 OVERVIEW
metal enclosure is made to house the TS-7200 family of Single Board
Computers as well as the TS-7800 and up to two PC/104 peripheral boards. The internal
power regulator efficiently converts unregulated 8-30 VDC input into reg5 VDC for
the TS-7200 family and 8-38 VDC input for the TS-7800 to +5VDC as required by the
SBC.
The TS-ENC720 Rugged Enclosure provides extra functions, including power conversion
and DB9 breakouts of the internal COM ports or additional I/O. Additional features include:
✔
Supports TS-7200 family and TS-7800
✔
Power converter: 8-30VDC to 5VDC
✔
8-38VDC to 5VDC for the TS-7800
✔
Surge suppression on power input
✔
Sturdy metal design reduces noise
✔
COM ports adapted to 9 pin Sub-D
✔
Dimensions 2-1/2x4-3/8x5-3/8 inch
✔
Power good LED visible
✔
Ethernet Status LEDs visible
✔
Extra DB9: COM3 or 8 DIO or 8 A/D
2 GETTING STARTED
2.1
Handling the Boar Safely
Before performing any set up or placement procedures, take precautions outlines in this
section.
✔
Be sure to take appropriate Electrostatic Discharge (ESD) precautions.
✔
Disconnect the power cable at the rear panel of the enclosure before moving,
cabling, or performing any set up procedures.
!
Warning
Inappropriate handling may cause damage to the board inside
2.2
Setup and Installation Instructions
Follow these guidelines for safety and maximum product performance:
✔
Observe local health and safety requirements and guidelines for manual material
handling.
✔
Set the enclosure on a level surface with adequate ventilation.
✔
Ensure the rubber feet are used for protection and stability on level surfaces.
✔
Wall-mount the unit if placement on a level surface is not available, or desired.
