GETTING STARTED WITH TS-ENC720
RUGGED METAL ENCLOSURE
2.3
Setup Tools
Depending on placement and cabling of the enclosure, you may need the following tools:
✔
Small flat-blade screwdriver
✔
Small Phillips screwdriver
2.4
Setup Procedures
After locating, setting up, grounding, and cabling the enclosure:
✔
Apply power to the unit (refer to some other section)
✔
Monitor COM1 using a terminal emulator to verify that the enclosure is operating
properly
2.5
Disconnecting AC Power
✔
Unplug the cord from the power source
✔
Disconnect the power cord from the rear panel of the enclosure
3 COMPONENTS
3.1
TS-782
The TS-782 is the board inserted in to the TS-ENC720 that provides the internal SBC with
2 DB-9 ports and 5VDC power regulation.
3.2
Front and Rear Panels
The TS-ENC720 front panel is shown on the first page of this manual.
The rear panel of the TS-ENC720 enclosure (shown above) has all of the input/output
connectors, including one COM port, two DB9 ports which can be used for an additional
COM port, 8 channel A/D, or 8 DIO pins, one ethernet port, two USB ports, two pin power
connector, as well as a power indicator LED.
