Triscan 1084 User Guide V13.doc
1084
Technology Solutions (UK) Ltd reserves the right to change the specifications of products and services without
notice. No part of this document may be reproduced in any form without the written consent of the author.
Page 9 of 19
5.3 Contactless smartcard and RFID operation
The Tri-Scan is designed to read RFID and contactless smartcards of ISO/IEC 7810 ID-1 size
in when they are inserted in the slot. It does not matter which way up the card is inserted.
Other RFID transponders and e-Documents can be read at the back of the Tri-Scan reader.
The transponder should be placed parallel to the back of the Tri-Scan reader.
Figure 6: Reading RFID transponders at back of Tri-Scan
5.4 Compatible peripherals
The Tri-Scan 1084 is compatible with any standard Motorola peripheral that does not use the
serial port (COM1). The serial port is not connected to the Docking Connector on the bottom
of the Tri-Scan 1084. If a peripheral is attached which uses the USB port then the Tri-Scan
1084 will disconnect from the USB port and switch the MC75 USB to the external port. This
means that the Tri-Scan 1084 cannot be used at the same time as a USB connection.
It is not possible to use the Tri-Scan 1084 with the Motorola vehicle cradle (part number
VCD7000-P000R). Third party vehicle cradle solutions which accommodate the Tri-scan 1084
on an MC70/75 are available from Brodit and RAM Mount.
