![background image](http://html.mh-extra.com/html/technosoft/ipos4808-vx/ipos4808-vx_technical-reference_1070600060.webp)
Technosoft 2018
52
iPOS4808 VX Technical Reference
4.5. Creating an Image File with the Setup Data
Once you have validated your setup, you can create with the menu command
Setup | Create
EEPROM Programmer File
a software file (with extension
.sw
) which contains all the setup data
to write in the EEPROM of your drive.
A software file is a text file that can be read with any text editor. It contains blocks of data separated
by an empty raw. Each block of data starts with the block start address, followed by data values to
place in ascending order at consecutive addresses: first data – to write at start address, second
data – to write at start a 1, etc. All the data are hexadecimal 16- bit values (maximum 4
hexadecimal digits). Each raw contains a single data value. When less then 4 hexadecimal digits
are shown, the value must be right justified. For example 92 represent 0x0092.
The
.sw
file can be programmed into a drive:
from a CANopen master, using the communication objects for writing data into the drive
EEPROM
from a host PC or PLC, using the TML_LIB functions for writing data into the drive EEPROM
using the EEPROM Programmer tool, which comes with EasySetUp but may also be
installed separately. The EEPROM Programmer was specifically designed for repetitive
fast and easy programming of
.sw
files into the Technosoft drives during production.