CAN UP 27 installation / Configuration of CAN UP 27 / Connection to ORF 4 Telematics service
CAN UP 27 online telematics gateway. Operation manual. Version 1.0
© Technoton, 2017
31
2.4.5 Connection to ORF 4 Telematics service
Configuration of
CAN UP 27
connection to
ORF4 Telematic service
and Internet-connection
status check is performed in
Communicator FM
submenu after session between CAN UP 27
and PC was established(see
2.4.3
).
To connect CAN UP 27 to ORF 4, configure FM Communicator in the following order
according to the table C.8 (see
annex C
):
1)
If using SIM card blocked with PIN-code, unblock it. To do that, enter PIN-code and
untick in blocking field (
PGN 63059
).
2)
Make settings for connection of GPRS-modem to the Internet (
PGN 63020
).
Check the parameters of GPRS-modem status to be sure there is Internet connection
(
PGN 63007
).
ATTENTION:
For GPRS settings, contact service center of SIM-card provider.
3)
Enter settings for CAN UP 27 connection with Server (
PGN 63068
).
IMPORTANT:
Data inserted into the fields of prefix (ID) should match with data
inserted into the fields ―Unique ID‖, they are entered during registration in the
ORF 4 Telematics service (see
ORF 4 Telematics service. User_manual
).
Check CAN UP 27 authentication settings on the Server to be sure that the Unit
authentication is made successfully and there is connection with the Server (
PGN 63099
).
ATTENTION:
If connection problems occur, contact
Service administrator
by
support@technoton.by
.
In configuration of
GNSS FM
according to the settings of GNSS (see table C.5,
annex C
),
check that built-in navigation receiver of CAN UP 27 is working properly and receives data
from satellite navigation (
PGN 62998
).
ATTENTION:
For good reception of navigation data it is necessary to
maximize
the view of the sky
at the place where the CAN UP 27 is being tested.
