32
TO INSTALL AND REPLACE BATTERIES IN THE THERMO-HYGRO
TRANSMITTER
The outdoor thermo-hygro transmitter uses 2 x AAA, IEC LR3, 1.5V batteries.
To install and replace the batteries, please follow the steps below:
1.
Remove the battery cover by pushing the battery cover upwards with
your thumb.
2.
Insert the batteries, observing the correct polarity (see battery
compartment marking).
3.
Replace the battery cover on the unit.
TO INSTALL AND REPLACE BATTERIES IN THE WEATHER STATION
The weather station uses 2 x C, IEC LR14, 1.5V batteries. To install and replace the
batteries, please follow the steps below:
1.
Remove the battery cover by sliding the
battery cover upwards.
2.
Insert batteries observing the correct
polarity (see marking).
3.
Replace compartment cover.
Note:
In the event of changing batteries in any of
the units, all units need to be reset by
following the setting up procedures. This is