1.Lower wing + Upper Fuselage 1PC 3. Equipment Canopy 1PC
2.Rudder 1PC 4. FPV equipment platform 1PC
The following 1-4 are the common installation steps of the Kraftei version and the FPV Kraftei version.
1.Put the rudder into the corresponding slot of plane
0
body, make sure A=90 , then glue it well.
2. Put the servo horn into the corresponding slot of
aileron, fix it with screw.
3. Fix the servo arm on servo with screw, put the servo
and servo wire into the corresponding slot as picture,
then fix the servo with glue
（
solid gum)
4. Cross the Z head of pushrod on servo arm, then
install another head on the servo horn with clip.
The Following 5-11 are the installation steps of Kraftei version
5. Put the motor mount A into the corresponding slot of
plane body, then fix it with glue.
6. Fix the motor on the motor mount A with screw.
7. Fix the 5*5 propeller and spinner on the motor
output shaft with screw.
8. Connect the ESC and motor well, then put it into
the equipment cabin.
9. Insert the servo wire and ESC signal line into the
corresponding slot of receiver, fix the receiver on
the side wall of equipment cabin with 3M double side
tape.
10. Put battery into the equipment cabin, then fix
it with battery velcro.
FPV Kraftei 650
Summary of Contents for FPV Kraftei 650 EPO
Page 1: ...FPV Kraftei 650 EPO ...
