Glue four wing fences to the wing, make sure that
the trailing edge of each wing fence is even with
the
aileron hinge line. Use a builder's triangle to
make sure that the wing fences
are perpendicular
to the wing.
Mount your ESC to the fuselage side, using a piece
of double-side foam
tape (not included).
Plug the servo and ESC lead into their proper slots in
your receiver,then mount your receiver to the side of
the fuselage, opposite the ESC, using
a piece of double-sided foam tape (not
included).Draw the antenna out the bottom of the
fuselage and secure it along its length, using pieces
of clear tape (not included). Do not cut the antenna
shorter. Allow the excess to hang beyond the back of
the fuselage.
Install your battery into the battery compartment,
using a piece of
hook and loop material.
Installing the propeller and decals.
Balance your propeller, then install it onto your
motor.Using a clean cloth wipe the airframe down
completely to remove any dust, debris and oil.
Summary of Contents for Malibu-F3P
Page 1: ......
