2
.
Vertical Stabilizer
Sand a 45º bevel into the left side of the leading
edge of the rudder.
Sand a 45º bevel into the bottom of the leading
edge of the four wing ailerons.
Cut
slots
the
slots
.
the same
on
stabilizer, then insert
the hinges into the
, and glue the cut
Insert the hinges into the
, then glue the cut
slots
.
Cut four slots where the hinges will be installed
.
,
make sure the distance is symmetrical
Cut
slots
the
slots
.
the same
on
wings and wing
ailerons, then insert the hinges into the
,
and glue the cut
Hinge the ailerons to the top wing, using the
same techniques that you used to hinge the
bottom wing.
Cut a piece of carbon fiber strip as long as the
slot of the wing, then glue it to the slot.
