TSR 2800-30 Hardware Installation Manual
-10-
3.2.2
Installing the Chassis on the Cabinet
The machine box of the router is fixed on the cabinet through the brackets. When
you fix the brackets, the front template of the router faces forward. The detailed
operations are shown in the following figure.
Note:
The previous example only describes how to install the router’s hull on one side of
a bracket. The installation on the other side of the bracket is same.
After the brackets are installed, install the router on the cabinet. See the following
figure:
3.3 Connecting the Port
3.3.1
Connecting the Console Port
TSR 2800-30 modularized router has one console port and one remote assistant
console port. Its attributes and usage method are described in this section.
1. Console port
The console port has a rate of 1200bps to 115200bps and a standard RJ45 plug,
the parity check is an option for the console port and the flow on the console port
can be controlled. Before configuring and monitoring the router, you must connect
the console port and the terminal (such as STAR-510G
+
) or PC’s serial port
through specific monitor cable and then run terminal imitation software (Windows
super-terminal). The cable is provided according to the host. The communication
parameters of the terminal serial port can be set to a rate of 9600bps, eight data
bits, one stop bit, no sum check bit and traffic control.
The RJ45 connector of the console port is shown in the following figure. The RJ45
plug corresponds to the RJ45 socket, whose pins can be aligned from left to right
with the value from 1 to 8.
