TSR 2800-30 Hardware Installation Manual
-5-
Chapter 2 Installation Preparation
2.1
Cautions
Similar to other electronic products, the semiconductor chip easily gets damaged if
you power on and off abruptly and frequently. To restart up the router of TSR
2800-30, you have to open the power switch after the power is cut down for three
to five seconds.
Avoid severe collision or falling down from the height to protect the parts in the
router.
Use correct outside ports to connect the router of TSR 2800-30. Do not insert the
telephone plug (4-line RJ11 plug) into the Ethernet twisted-pair port or the console
port (RJ45 8-line socket); do not insert the Ethernet twisted-pair plug into the
console port. Similarly, do not insert the console cable into the Ethernet
twisted-pair port (RJ45 8-line socket).
Note:
1) When you plug or dial out the power line, keep the power line horizontal with
the power socket.
2) When the lifetime of our products ends, handle them according to national
laws and regulations, or send these products to our company for collective
processing.
2.2
Safety Advice
Safety Principles
z
Keep dustless and clean during or after the installation.
z
Put the cover at the safe place.
z
Put tools at the right place where they are not easily falling down.
z
Put on relatively tight clothes, fasten the tie or scarf well and roll up the
sleeve, avoiding stumbling the chassis.
z
Put on the protective glasses if the environment may cause damage to your
eyes.
z
Avoid incorrect operations that may cause damage to human or devices.
Safety Notices
z
The safety notices mentioned here means that improper operation may lead
to body damage.
z
Read the installation guide carefully before you operate the system.
z
Only professionals are allowed to install or replace the router.
z
Pull out the AC power socket and close the direct-current power before
operating on the chassis or working beside the power source.
z
The final configuration of products must comply with relative national laws
and regulations.
