www.techsys.com.au
Version 1.3 11/12/11
16
C o r p o r a t io n
Main Menu
Sub Menu
Units
Defaults
Range
INPUTS
Program Input 1
selection
System Pause,
*Alt 2 Settings
Program Input 2
selection
Pump 1 Protection,
*Alt 3 Settings
Program Input 3
selection
Pump 2 Protection,
*Cut In,
Program Input 4
selection
Pump 3 Protection,
*Cut Out,
Program Input 5
selection
High Limit,
Low Limit,
Program Input 6
selection
Low Limit,
High Limit,
Program Input 7
selection
No Flow,
System Pause,
Program Input 8
selection
*Alt 2 Settings
*Pump 1 - 6 Protection,
Program Input 9
selection
*Alt 3 Settings
*Pump 1 - 6 Stop,
Program Input 10
selection
Reset,
*Pump 1 - 6 Manual Run,
Program Input 11
selection
Cycle Pumps,
Fire Mode,
Program Input 12
selection
Aux Input 1
Cycle Pumps,
Reset,
No Flow,
Aux 1, Aux 2, Aux 3,
*Pump 1 - 6 No Flow Prot,
*Level Cut In 1,
*Level Cut In 2,
*Level Cut In 3,
*Level Cut In 4,
*Level Cut In 5,
*Level Cut In 6,
*Level Cut Out 1,
*Level Cut Out 2,
*Level Cut Out 3,
*Level Cut Out 4,
*Level Cut Out 5,
*Level Cut Out 6,
* Alternate 2&3 settings only apply when operating in "Pressure", "Temperature", "Flow" or "Single Level" modes.
* "Cut In" and "Cut Out" are only visible when operating in "Switched" Mode
NOTE: Also not visible when "Switched" "Multi level" is in operation but are available in Single Level Operation
* Pump Protection 2 - 6 are only visible if "Number of pumps" is set accordingly
* Pump Stop 2 - 6 are only visible if "Number of pumps" is set accordingly
* Pump Manual Run 2 - 6 are only visible if "Number of pumps" is set accordingly
* Pump NoFlowProt 2 - 6 are only visible if "Number of pumps" is set accordingly
* Level Cut In 1-6 & Cut Out 1-6 are only visible when operating "Switched" "Multi level"
