24
If the receiver does not operate normally due to external effects such as static electricity, disconnect the power plug from the outlet
and insert again to return to normal operating conditions.
Considerable noise in
radio broadcasts.
Incorrect frequency.
Tune in the correct frequency.
The antenna is not connected.
Connect the antenna.
RF (AC-3) and/or digital cables are
near the antenna terminals and wires.
Route RF (AC-3) and digital cables away from the
antenna terminals and wires.
(For FM) The FM antenna is not fully
extended or is poorly positioned.
Fully extend the FM wire antenna, position for best
reception, and secure to a wall.
(For FM) The signal is weak.
Connect an outdoor FM antenna.
(For AM) The AM antenna is poorly
positioned.
Adjust the direction and position for best reception.
(For AM) The signal is weak.
Connect an additional internal or external AM antenna.
Interference caused by other equipment
(for example, fluorescent lights, motors).
Turn off the equipment causing the noise or move it away
from the receiver.
Place the antenna farther away from the equipment causing
the noise.
Broadcast stations
cannot be selected
automatically.
The signals are weak.
Connect an outdoor antenna.
The display is dark or
off.
The dimmer is on.
Press
DIMMER
repeatedly to return to the default setting.
When listening to the
music in stereo, left/
right speakers sounds
are reversed.
Speakers are connected wrong.
After checking, if needed, reconnect.
Low hum or buzz
sound.
Power line of a fluorescent light is
installed near this product.
Place this product as far away as possible from electric
devices with interference.
Sound is only heard
from one channel.
One of the input cords is disconnected.
Connect the input cords securely.
The speaker level is set to one side.
Adjust the speaker level.
Sound cuts off or there
is no sound even
though power is on.
Speaker impedance is less than prescribed
for this unit.
After turning off the power and then turning it on again,
reduce the volume or change to the correct 6-ohm speakers.
Low bass response.
Speaker po/–) is reversed.
Check all speakers for correct polarity.
No sound from the rear
speakers.
Surround Mode is set to
STEREO
.
Set the mode to the desired surround mode position.
Source being played is not recorded or
broadcast in surround sound or stereo.
Use surround or stereo source.
One or more rear speaker wires is not
making good contact,
Check all rear speaker wires for good connection.
No sound from the
center speaker.
Surround Mode is not set to
DTS
,
DOLBY
DIGITAL
,
DOLBY PRO LOGIC
Set Surround Mode to
DTS
,
DOLBY DIGITAL
,
DOLBY PRO
LOGIC
Symptom
Cause
Remedy
