7
USE
Unroll the power cord completely.
Check that the tension in force in the country where you are corresponds to
that indicated on the apparatus.
Connect the apparatus in a correct socket-outlet, (and connected to the
ground if the unit is Class I), to avoid any danger.
Disconnect the power source cable before any operation of cleaning of
maintenance and accessories assembly.
Stand the appliance on a table or flat surface.
The item must not be left unattended when it is connected to main supply.
The item is not to be used, if it has been dropped & if there are visible signs
of damage or if it is leaking.
Never modify the appliance in anyway.
Comb or brush your hair always before using this product.
Use this appliance on damp or dry hair but never on wet hair.
Do not use on synthetic hair or wigs.
NOTE:
Never remove the brush during use ... risk of burns.
Wait until the unit is cooled to remove the brush.
When connect the equipment be sure the button is set to 0 = off (OFF)
To adjust the heat as a personal need
3 = Normal to mild drying and shaping
2 = Fast for quick drying
1 = Mild heating
To work the hair, do not roll too much hair around the brush.
Wrap the hair from the bottom of the head, strand by strand and then
upwards towards the top of the head.
Let hot air for a few seconds.
Allow to cool before removing the hair left on the brush.
ASSEMBLING THE BRUSH
• To assemble the brush with the device, introduce it into the cylinder at the front
of the device.
• Ensure that the groove of the brush is in front of the pin from the handle.
• When they are online, push the 2 parts togethe
r until you hear a "click".
• To remove the brush, press the release button and pull it straight out.
