9
FILLING THE WATER TANK
1. Set the steam control to the closed position.
2. Hold the iron vertically by the handle and tilt it 10º to fill it. Run the water
through the filling inlet.
Notes : Never exceed the "Max" level indicated on the tank.
Never use scented substances.
3. If water has leaked out of the tank, Clean the outside of the tank.
4. After ironing, always empty the water tank.
5. The tap water is usable. However, if the water in your area is very hard, it is
advisable to use distilled water.
BEFORE FIRST USE
Fill the tank with water before connecting it. (without exceeding the maximum
level).
Plug the iron into an outlet in good condition.
Selecting the temperature • • The indicator light comes on, indicating that the iron
is starting to heat up.
When the desired temperature is reached, the indicator goes off and the iron is
ready for use.
For this first use, test clean cloth or used cloth.
First, let the steam come out for at least 1 minute and press the express steam
button and the spray button several times, to clean the tank of any manufacturing
impurities.
Notes: During this operation a slight smoke may be released from the hearth or
iron for a few moments; This is normal.
During ironing, it is normal for the indicator light (Means the thermostat) to
turn on and off automatically to maintain a constant temperature.
It is always easier to iron fabrics or slightly damp clothes.
USE
•
Unroll the power cord completely.
•
Check that the tension in force in the country where you are, corresponds to
that indicated on the apparatus.
•
Connect the apparatus in a correct socket-outlet, (and connected to the
ground if the unit is Class I), to avoid any danger.
•
Disconnect the power source cable before any operation of cleaning of
maintenance and accessories assembly.
