Note: When using the water spray function, ensure that there is enough water in
the water tank, and you may have to pump the spray button serval times at first
time you use the iron in order to start the spraying function.
BURST OR VERTICAL STEAM IRONING
● Press the burst of Steam button to generate a powerful burst of steam that can
penetrate the fabrics and smooth the most difficult and tough creases. Wait for
a few seconds before pressing again.
● By pressing the Burst of Steam Button at intervals you can also iron vertically
(curtain, hung garments, etc.)
Note: The burst steam function can only be used at high temperature. Stop the
emission when the pilot light turns on, then start ironing again only after the pilot
light has turned off.
DRY IRONING
For ironing without steam, follow the instruction in section “steam ironing”,
however, the steam control turning knob should remain in position “O” (no steam).
SELF-CLEANING
It is good to clean the iron every 10-15 days!
To do this:
Fill the water tank
Push the steam control knob (3) to 0 position.
Set the thermostat (7) to the "MAX" position
Connect the iron to the power supply.
Wait for the heating indicator light to come on.
When the light is on, unplug the power supply and position the iron above a sink.
Immediately press the Auto Clean button (6), the water will drain from the steam
spray holes of the soleplate.
When the water tank is empty and the water is no longer flowing,
Run a soft cloth or damp sponge on the soleplate to remove residue.
Put the iron on a stable support until it is dry.
Dry the sole before storing the iron.
CLEANING AND MAINTENANCE
Before cleaning, always: switch off the appliance, disconnect the apparatus and
let it cool.
Clean the outside of the apparatus with a sponge or slightly wet linen.
Never plunge the apparatus in water or all other liquid!
Do not use abrasive cleaners, gritting, or metal brush or another cutting object.
9
