8
Directions for Use (GB)
Please read the instructions carefully before using the product and keep it for future reference.
This product is intended for household use only.
1.
Specifikation
Model
TTF-91
TTF-91 Inox
Voltage
220-240 V
, 50 Hz
220-240 V
, 50 Hz
Refrigerant
R600a, 33g
R600a, 33g
Volume
68 liter
68 liter
Weight
31 kg
31 kg
Color
White
Silver gray
Door panel
White
Stainless steel
This appliance corresponds to the CE directives.
2.
Before first use
Remove the exterior and interior packing material and tape. Dispose the packing material
according to your local environmental requirements.
Check for transport damages.
Before connecting the freezer to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
Clean the interior surface with lukewarm water and mild detergent using a soft cloth.
3.
Installation
Installing Your Freezer
This appliance is designed to be free standing only, and should not be recessed or built-in.
Place your freezer on a floor that is strong enough to support the freezer when it is fully
loaded.
Make sure to level the appliance properly. The feet are adjustable for this purpose. If out of
level the door function can be bad and not standing steady can result in vibrations and
increased noise.
Allow 20 cm of space between the back and sides of the freezer, which allows the proper air
circulation.
Locate the freezer away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the freezer not to
perform properly.
Avoid locating the freezer in moist areas.
Plug the freezer into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center. Do not use an extension cord.
If the appliance during transport or installation has been laying or tilted more than 45°,
allow the unit to rest standing upright for at least 6 hours before switching it on.
