21
Remove transport bolts
Before using this washing machine, transport bolts must be
removed from the backside of this machine. Please take the
following steps to remove the bolts:
1.Loosen all bolts with spanner and then remove them.
2.Stop the holes with transport hole plugs.
3.Keep the transport bolts properly for future use.
Select the location
Before installing the washing machine, the location characterized as follows shall be selected:
- Rigid, dry, and level surface (if not level, please make it level with reference to the following
figure “Adjust Leg”)
- Avoid direct sunlight
- Sufficient ventilation
- Room temperature is above 0 C
- Keep far away from the heat resources such as coal or gas.
Make sure that the washing machine will not stand on power cord. Do not install the washing
machine on the carpet floor.
Adjust Leg
1.When positioning the washing machine, please first check if
the legs are closely attached to the cabinet. If not, please turn
them to their original positions with hand or spanner and
tighten the nuts with spanner.
2.After positioning the washing machine, press four corners on
top cover of washing machine
in sequence. If the washing machine is not stable when being
pressed, this leg shall be adjusted
3.Ensure the positioning status of washing machine. Loosen the
lock nut with spanner and turn the leg with hand until it closely
contacts with the floor. Press the leg with one hand and fasten the nut closely to the cabinet with
the other hand.
4.After being locked properly, press four corners again to make sure that they has been adjusted
properly. If it is still unstable, it has to repeat Steps 2 and 3.
Connect inlet pipe
Connect the inlet pipe as indicated in the figure. For the model
which has hot valve , please connect the hot vale to hot water
tap. Energy will decrease automatically for some program.
Install inlet pipe
1.Connect the elbow to tap and fasten it clockwise.
2.Connect the other end of inlet pipe to the inlet valve at the
backside of washing machine and fasten the pipe tightly
clockwise.
Notes: after connection, if there is any leakage with hose, then
repeat the steps to connect inlet pipe. The most common type
of tap shall be used to supply water. If tap is square or too big,
then standard tap shall be changed.
