13
16.7 Moving interlocking guards for bending area:
The guard for the moving parts is a hinged sheet metal plate that can be opened. It is a moving guard
provided with a safety electrical contact - called tampering prevention interlock
– which stops
immediately the machine in case it is open even partially; the machine cannot start since the guard is
completely closed.
16.8 Fixed guard for cutting area:
The cutting area is guarded by a fixed steel protection.
17
One-man safety devices
The use of protection gloves and safety shoes is compulsory as safety devices for the worker.
18
Residual risks
1)
Mechanical risks: In the bending area the residual risk consists in the possible impact of hands
against the guard.
The cutting area presents the risk of shearing for the upper limbs.
The two protections shows a warning signal.
2)
Electrical risk:
The machine is supplied with 400 V and it gives an electrical residual risk.
3)
Noisiness:
The level of the equivalent continuous sound pressure ponderate A of the
machine results less than 70 dB during the bending and cutting operation.
19
After-sales service during guarantee
1)
The machines have a guarantee of 24 months from the date of delivery, and the guarantee is
valid only if the GUARANTEE CERTIFICATE (sheet enclosed) has been duly filled in and sent
to TECMOR company. OTHERWISE THE MACHINE WILL NOT BE COVERED BY GUARANTEE.
2)
The producer undertakes to repair any manufacturing defect found during the period of guarantee.
That means the free replacement of the faulty parts after the producer has made sure of the
manufacturing or material defects.
3)
The user shall send the producer the faulty part - covered by guarantee - to make it repaired. The cost
and the risk of the transport of the faulty or repaired / replaced parts are borne by the user.
4)
If the repair of the replacement must take place where the machine is installed, the travel, board and
lodging expenses for the producer’s technicians will be invoiced to the user. The replaced parts will
not be charged.
5)
This guarantee does not cover the parts subject to a particular wear or wrongly used, not maintained,
overloaded or modified
.
6)
The after-sales service during the period of guarantee will be carried out promptly; however TECMOR
company will not answer for any possible delay.
20
Spare-parts
A complete catalogue of the spare parts is supplied at customer’s request or is available at the area
dealer. According to the EC legislation, TECMOR grants delivery and availability of spare-parts for
maximum ten years after the date of purchase.
Summary of Contents for PG 26 mono-phase 2 speed
Page 2: ......
