Manual lock
The balancer is fitted with a manual locking system (Fig.2): push and turn the pin 6 (Fig.2) by 90°(position A) to lock drum rotation; push and turn
the pin 6 (Fig.2) by 90°(position B) to operate as usual.
WARNING: do not leave the balancer with the drum locked and no hanging loads.
WARNING: if the balancer’s cable is not fully wound, and no load is applied to it, DO NOT do anything but contact the customer
service at once.
WARNING: always comply with the safety regulations when using electrical appliances.
INSPECTIONS AND MAINTENANCE
ATTENTION: check the condition of the ground cable and the tightening of the screw
(EN 13463-1:2009) on a regular
basis (for instance, once after every work shift) and carefully remove dust so that it will not build-up, i.e. not more than 5
mm.
ATTENTION: replace the drum every 100,000 (hundred thousand) cycles.
Maintenance may be carried out only by skilled and authorized personnel.
- Visually inspect the balancer on a regular basis (for instance once at each work shift). Specifically, check the state of the suspensions (33)
and S (Fig.1), the fixing screws & self-locking systems (if used), and the condition of the hooks and cable.
If the cable has the defects shown in (Fig.3), replace it immediately.
Do not make any modification to the cable unit and, specifically, DO NOT SHORTEN the cable: if need, please get in touch with TECNA S.p.A.
- check that the cable’s movement is smooth and that it does not make any strange noises
- do not lubricate the balancer with flammable or volatile fluids
- do not remove any labels. Replace any damaged labels
- the balancer must be inspected at least once a year by skilled, authorized personnel.
Never disassemble the balancer. Maintenance is to be carried out only by skilled, authorized personnel.
The balancer must be disposed of complying with prevailing rules and regulations at the end of its work life.
Warranty
The use of non-original TECNA spare parts will negatively affect safety and performance and will, in any case, void the
warranty.
ISTRUZIONE BILANCIATORI_man 9084-1_serie 9354AX-9359AX_06-2012.pmd
13/09/2012, 9.53
7
