TECNICCAT MAMNET ECO 15, Manual

9  

MENU CONFIGURATION: 

The screen usually shows the production programmed on the upper line and the system status 

on the lower line. There are two menus; the INFO information  menu  and  the  CONFIG             

configuration menu. 

LANGUAGE

 screen: Pressing 

CONFIG

 shows the language selected at this time. The      

language can be changed using the +/- buttons and searching for another: (English, Spanish, 
Catalonian, French, Flanders, Italian and Russian*). Whether the language is changed or 
not, pressing 

CONFIG

 passes to the next screen and pressing 

ENTER

 returns to the start 

screen. 

ORP

 screen: Shows the current selection. The +/- buttons are used to change the current 

option (- = No) (+=Yes). If “No” is selected, the 

pH

 screen will appear. If the option is 

YES, by + / - we can choose how we want it to work: 4-20mA, 0-10V, NC contact, NO 
contact, FIX or ORP 

(for ORP see page 24)

. Once selected, by pressing 

CONFIG

 we 

then pass to the next screen and by pressing 

ENTER

 we return to the home screen.   

 
Screen 

pH

: If we choose "NO" then the screen goes to the 

CLEANING HOURS

. If the 

option is YES we then open the 

pH

 menu 

(see page 26).

CLEANING HOURS

 screen: Shows the current selection, if the selection is changed by 

pressing 

CONFIG

, the 

SEAWATER

 screen will appear. Use the +/- buttons to change 

the current option (no cleaning or every 3h, 4h up to 8h). The hours selected are those that 
will change the polarity. 

The higher the calcium content in the water, the less time will 

pass between changes in polarity! 

Once the time has been selected by pressing 

CONFIG

, 

the next screen will appear and pressing 

ENTER 

will return to the start screen. 

SEA WATER 

screen: Shows the current selection. If the selection is not changed, pressing 

CONFIG

 will go to the 

ELECTRODE HOURS USE

 screen. Use the +/- buttons to change 

the current option (Yes / No). Press 

ENTER

 to return to the start screen. 

ELECTRODE HOURS USE

 screen: shows the total and partial hours of operation: Pressing 

CONFIG

 goes to the next screen 

SET TO ZERO

 and pressing 

ENTER

 returns to the start 

screen. 

SET TO ZERO 

screen: Use the + / - buttons to set the partial hours counter to zero. The total will 

not change. When the 

CHECK CELL

 LED is illuminated, requesting to check the electrode , 

and once it has been checked, go to this screen and set the partial to zero, which will turn off the 
LED. If do not set to zero (No -) is selected, the system will return to the start menu. If yes 
(Yes +) is selected, the set to zero screen will be displayed and the system will return to the 
start screen. 

H  HOW TO MOVE AROUND THE MENUS: