TECNO AIR SYSTEM
Essege Group
pag. 30 di 40
DISPLAY TEST INDICATIONS
DISPLAY
TEST
SIGNIFICATO
OFF
Extinguishing phase in progress, lasting about 10 minutes
AC
First-stage stove ignition, bioethanol loading and waiting for flame ignition
AR
second stage ignition stove, flame enrichment.
PA
Step followings ignition phases
PH
Phase heating stove
P1-P2-P3
Power level set
10...30°C
Degree desidered temperature in the stove room
SF
Stop Flame: Operation block for likely bioethanol depletion
CP-TS-PA
Control menu available exclusively for CATs
(Technical Support Center)
AF
Ignition failure: ignition failure block
H1....H7
Allarm system, the number identifies the alarm causes
Bat1
Finished clock battery (type CR2032)
When the stove is in stand by mode, it visualizes on display OFF
if the stove is in MANUAL or AUTOMATIC mode.
On display it visualizes the text
AC
(a); overcamed some control cycles and following when the ignition
occours, on the display it visualize the text
AR
(heating ignition), this phase will last for some minutes it
allowing the correct ignition and heating of the heater exchange.
After a few minutes, the heater will go off during the cleaning phase
PA
, following on heating phase will be
on display
PH
and following in work phase, indicating the selected power in case of manual operation,
or indicating the selected temperature in the case of automatic operation.
6. IGNITION/FUNCTIONING/ PROGRAMMING
On stand-by stove press the ON/ OFF button and start the ignition procedure.
Position the switch
C
in position ON,
