Tecnodom MINI COLD ROOM 100, Installation And Operation Manual

31

EN

• 

MINI Cold-Room predisposed for remote unit.

Both of them include water pipe drain with siphon predisposed for water drain connection ( to be 
install by the 
customer)

You never install the MINI Cold-Room without siphon and to connect more drains of the same MINI 
Cold-Room together.  Each drain must have only one siphon. 

For more information please,  see the APPENDIX  3 “VERSION”.

1.5  INSTALLATION INSIDE YOUR SHOP/RESTAURANT / WORKROOM

It is advisable to install the 

MINI Cold-Room

 inside an area with an air conditioning system. Please 

note that malfunctions may arise in areas that are not provided with air conditioning, e.g. conden-
sation formation 

ATTENTION

In order to allow a good functioning of the 

MINI Cold-Room

 please draw attentions to the fol-

lowing instructions:

• 

Do not place the MINI Cold-Room to a direct exposure of sunlight and to all the other 
means of irradiation,

 such as high intensity incandescent lights, cooking ovens, heating radiators.

• 

Avoid to close the air in-take

 of the monoblock or built-in unit.

•  Do not put any material as carton or others, on the top of the MINI Cold-Room

 in 

which is positioning the monoblock unit or the condensing unit.

• 

Do not positioning the MINI Cold-Room inside the area in which there is to much hu-
midity

 (possible making condensation of  the surface of the MINI Cold-Room).

•  Do not positioning the MINI Cold-Room inside a close cavity

  (there is no circulation of 

air and the MINI Cold-Room will not run properly).

• 

Do not positioning two or more MINI Cold-Rooms  back-to-back position

 (the unit will not be properly).

Verify that in the installation room there is enough air turnover, even during closing and rest hours. 
In this way the expansion/condensing unit will work correctly.

1.6  WALL MINIMUM DISTANCE

In order to allow a good performance of the MINI Cold-Room, during the installation you must 
respect the MINIMUM WALL distances : 

not less than 5 cm all around the Cold-Room and not less than 40 cm from the momoblock, posi-
tionated on the top af the Cold-Room, to the ceiling of the room where the Cold-Room is placed.

1.7  MINI COLD-ROOM WITH BUIlT- IN UNIT

If  the MINI Cold-Room is fi tted with built-in condensing unit, check if  the foot board obstructs air circulation. 
Do not put any  cartoons or any others materials and do not  close the air in-take and out-take on 
all sides of  the MINI Cold-Rooms. 
For a good running and performance of the MINI Cold-Room, do not obstruct the condensing unit ventilation.