I.T.S. Ital Trade Services srl ST 1200 Operating Manual
17
6. Adjusting angle cut
The cutting angle could be changed from 30,0° by
means of turning the pipe holder to the left , and 68,0°
by means of turning the pipe holder to the right.
To adjust the cutting angle follows the points here
below:
1)
Release the bolt on the graduated scale
2)
Turn the pipe holder to the desired position
3)
Tighten the bolt on the graduated scale
7. Blade’s Guide and blade protection
Adjustment
In order to maintain the saw blade into the correct
position during the cutting , it’s necessary that the
blade’s guide is adjusted according to the pipe’s
diameter to be cut, therefore the operator to
adjust should act on the screws
A
and
B
by loosen
and tighten them.
Figure 11. The blade’s guide