I.T.S. Ital Trade Services srl ST 1200 Operating Manual
20
h. Maintenance
BASIC MACHINE - ROLLERS
It's strongly suggested to keep always the machine clean with particular care of the cylinder's
stems and sliding bars .
Keep attention while insert pipes on the rollers avoiding to damage the machine's slide bars.
Keep always clean the machine by using compressed air in order to remove material shavings
ARCH
Check weekly the wearing state of the blade and controlling if there are cracks at the base of the
teeth
Monthly, open the protecting plates and remove the shavings.
Grease the trolley of the idler pulley when necessary.
HYDRAULIC UNIT
Check periodically the oil level. If the oil level is under 5 cm from the upper edge of the tank, add oil
by using oil type: EESSO NUTO H 68, MOBIL DTE 26, SHELL TELLUS 68, AGIP OSO 460, ISO 46.
Keep the hydraulic unit clean.
CONTROL BOARD
Clean the control board only with detergents for electric/electronics components
Keep always clean the electrical part of the machine by using compressed air in order to blow
away dust and dirt. Keep care to gently blow, to avoid any damage to the devices.
Each six months clean the filters of the fans.
GENERAL CONTROL
In case something will happen on the machine or in one component, kindly contact our technical
assistance department.
Warning: Do not use water to clean the machine!!!
