17
461308171 06/2014
12
OVEN DOOR REMOVAL (for certain models)
The oven door can be removed to give easier access
to the oven when cleaning.
To remove, proceed as follows:
• Open the oven door and insert rivet or nail (R) in the
hole (F) of the hinge (fig. 11).
• Partially close the door, forcing it upwards at the
same time to free stop tooth and hinge sector.
• Once the hinge is free, pull the door forwards tilting
it slightly upwards to free sector.
• To reassemble proceed in the reverse order, paying
attention to the correct position of sectors.
INSTRUCTIONS FOR THE USER
OVEN SEAL
The oven seal guarantees the correct functioning of
the oven. We recommend you:
• clean it, avoiding abrasive tools or products.
• check its state now and then.
If the oven door seal has become hard or is
damaged, contact our Service Centre and avoid
using the oven until it has been repaired.
11
Some of the problems occur because of simple maintenance oversights or operation mistakes and can easily be
resolved without having to call for technical assistance.
PROBLEM
REMEDY
The appliance is not working
• Make sure the gas cock is open
• Check the plug is in
• Check that the knobs are set correctly for cooking and then repeat the
operations given in the handbook
• Check the electrical system safety switches (RCD). If there is failure in
the system call an electrician in.
The thermostat is not working
• Call our Service Centre
The oven light does not switch on • Make sure the lamp is firmly screwed in place
• Buy a lamp for high temperatures at one of our Service Centre and fit
it following the REPLACING THE OVEN LAMP paragraph.
TROUBLESHOOTING
REPLACING THE OVEN LAMP (fig.12)
In the event one or both oven lamps need replacing, the
new lamps must comply with the following requisites:
15 W - 230 V~ - 50 Hz - E 14 - and must be resistant
to high temperature (300°C) and follow these
instructions.:
>
Draw out the side guide rails as described above.
Then, remove the glass protection cap (V) from
the bulb socket, lifting it with a screwdriver placed
between the cap and the oven wall and replace the
lamp (L). Fit the accessories back in reverse order.
