TECNORD
RC-DBX/PCM/NBM
Use and Maintenance Manual
Page
7/23
3
INSTALLATION
WARNING !
¾
Only a qualified and specialized technician should install the receiver of a radio control to the electrical system
of a machine (see par.4, Maintenance) who is acquainted with both the electrical circuit of the machine and the
radio control technical features.
¾
During the entire installation phase both the transmitter and the receiver must be turned off.
¾
All of the regulations on the health of the staff working within the installation area, together with any local
regulations in force, and those on fire prevention must be observed.
¾
TECNORD declines all responsibility, neither does it grant any guarantee whatsoever for any damage caused to
things or persons due to the improper or careless use of this equipment or due to the non-observance of any
regulation or that, which has been indicated in the operating instructions.
3.1
DBX Receiver Unit sample drawing
3.2
Positioning the receiver
WARNING !
When positioning the receiver, check that it is not being screened by large metallic surfaces.
For the Radio Control to operate smoothly, it is necessary that the receiver should be installed in such a position as to allow the
maximum reception of radio waves from the antenna. The metallic parts of the machine to be controlled that surround the receiver
create a barrier that interferes with reception
In most cases, the receiver can be housed on any side of the machine or, if necessary, for installations on vehicles even inside the
glass cabin. It is also necessary to place the receiver where it is accessible and safe to work both for those who carry out the
installation of the electrical connections and for those who will do the future maintenance.
Make sure to keep the display visible to the user in order to ease the diagnostics of the equipment during operations.
Should such an installation be performed on board mobile machinery or on a vehicle, then you should attach rubber bumpers.
These rubber bumpers will prevent strong vibrations from the machine to the receiver.
3.3
SHW Transmitter Unit sample drawing
