12 of 20
II_ DigiTech_01_eng
Installation instructions
DigiTech
The spindle must be inserted between a minimum of 7 mm to a maximum of 12 mm inside the
lock.
WARNING: do not insert the spindle up to the lid of the lock, but leave some margin to allow the
movement of the cable and to prevent any damage.
Make sure the cable is fully inserted and locked in the groove of the spindle.
Remove any residues deriving from the cutting of the spindle that could damage the cable.
Insert the cable connector into the square hole present in the bottom of the lock and make it come
out from the opposite side.
MotorLock and Motor SpringBolt locks installation instructions
MotorLock and Motor SpringBolt locks are locks with, respectively, a motor driven dead bolt and
a motor driven spring bolt, whose block is carried out by a motor.
By entering a valid code, the motor retracts the bolt which remains in the open position for about
8 seconds and then automatically returns to the locked position.
If the manual relocking option is selected, the bolt closes by pressing and holding the button
.
The distance between the SpringBolt lock and the locking edge must
be between a minimum of 3 mm and a maximum of 8 mm.
When locked, there must be a 0.5mm
gap between lock bolt and locking
surface.
Secure the cable, avoiding to stretch it too much, inside the specific
groove on the lock cover and fix the lock using the appropriate
mounting screws.
Connect the keypad cable to the lock connector "ENT", making sure it is fully inserted and locked.
Any alarm interface or battery holder will be connected to the lock connector “BAT”.
To remove the cable, bring the connector upwards and carefully pull it out.
Summary of Contents for DigiTech Series
