IU_BasicLine_01_eng
3
LOCK FEATURES
Codes
One Manager
: can open, changes his code, manage users, program time delay, audit
users and lock.
User
: can open and change their own codes.
New codes are rejected when less than 2 digits are different from existing codes.
Time Delay
Time delay programmable from 0 (no time delay) to 99 minutes. Open window from 1 to 19
minutes.
During time delay enabled LED flashes at two seconds intervals. Open window is indicated
by LED then buzzer at 1 seconds intervals alternately (once LED, once beep).
Battery low warning
If battery low (<6V) during motor activation, multiple beeps.
Time penalty
When entering code, a time penalty of 5 minutes will be started after the 4th consecutive
wrong code entered. During time penalty, LED flashes at 10s interval, no access possible
to lock.
Any key pressed during time penalty emits a long beep.
After time penalty, two consecutive wrong codes will start it again.
Additional features
TD override user #9 – When TD active, user #9 always override TD in “dual mode”.
Basic Input/Output features – If standard I/O is activated, silent alarm (+1 on combination
last digit will trigger an alarm output signal) and disable input features are active through
additional 4-wires on-board connector.
Recommandations
•
It is strongly recommended to immediately change the factory codes
•
For security reasons, do not chose codes which could be easy to guess (e.g. 1 2 3
4 5 6)
•
For your new code, do not use any personal data like birthdays or any other data,
that could be derived by knowledge of your person.
•
After code changing, the lock must be tested several times with door in open state.
•
Do not open the lock case, otherwise you compromise the function of the lock and
warranty will be void.
•
In order to prevent any possibility that the code become public or known by
unauthorized persons we strongly recommend to store any data and/or code in a
safety place, where only its rightful owner can access.
