22
MAINTENANCE
REPAIRS
MULTIPOSICION HEAD (ADJUSTMENT)
In the event that the articulated head doesn’t perfectly lock its
movement or if on the contrary, it moves with difficulty on its idle position, it
should be adjusted.
If the coupling on the motor side is to be adjusted, then the motor
should be removed from the articulated head or if the coupling to be adjust is
the other one, remove the plastic cap.
To perform the adjustment,
set the handle (17, page. 4) in its lock
position, drive in a 5 mm ALLEN
spanner, loosen the lock nut by
turning it counter clockwise, drive in
the 4 mm ALLEN spanner,
precision-adjust the screw by turning
the screw clockwise = greater
coupling slippage, counter clockwise
= greater coupling locking effect.
Once adjustment has been
performed, drive in the 5 mm
ALLEN spanner and tighten the lock nut by turning it clockwise.
FRONT DAMPER (SUBSTITUTION)
Remove the front bellow ((2, page 4) and (14, page 6))
Pull out the two 8 mm ALLEN screws.
Pull out the fork stop ALLEN screw.
With the arm in its horizontal position, turn the knob counterclockwise
in order to release the damper up to it becomes completely loose ((14,
page 4) and (4, page 6))
Remove one Seeger ring along with the damper strut in the fork.
Remove one Seeger ring along with the damper strut in the arm
replace the damaged damper with a new one and reassemble it in the
reverse order.
Damper ref. 262 037 04 (R-500)
Damper ref. 512 010 04 (R-500 RH)
