17
Sistemi
INSTALLATION AND COMMISSIONING
IMPORTANT!
The curtain must be installed by qualified personnel, and in compliance with the IEC 64.8
standard. (Electrical connections), and according to this manual.
Tecnosystemi air curtains can be installed above doors, at a minimum height of 1.8 m. above the floor,
and must be positioned in such a way that the curtain’s opening is positioned centrally vis-à-vis the
door opening. The curtain must never be installed outside of the door, or anywhere exposed to the
elements (rain, wind, etc.).
Ensure that it cannot come into contact with rain, or suck in water, as this could cause short-circuiting.
The air curtain must be fastened to the wall using the holes positioned on the back. The installation
engineer shall be responsible for choosing the most suitable type of fastening for the specific wall to
which the curtain is to be fixed.
A gap of about 15 cm. Must always be left between the upper protective grill and the ceiling, in order
to enable the curtain to take in air. Do not obstruct with sheets or built-in panels, and do not position
the curtain immediately beneath an electrical socket. Each machine is sold complete with a fitted plug
and a remote control device.
AIR CURTAINS LABEL
3° speed (Max)
3 LEDS ON
2° speed (Max)
2 LEDS ON
1° speed (Max)
1 LED ON
WARNING!
Before performing the maintenance operations, remove the power supply by positioning
the general switch of the system on “off”.
DO NOT INSTALL the air curtain in the following conditions:
1. Make sure that it can in no way come into contact with rain, or draw water because these
conditions could cause a short circuit.
2. In the presence of flammable vapors.
3. Temperature above + 40 ° C or below -10 ° C; relative humidity ≥90%.
4. In the presence of explosive mixtures or in the presence of gas.
5. Relative humidity higher than 90%.
CONDITIONS OF USE
Summary of Contents for Apply air Aria 3 12400011
Page 23: ...NOTE Sistemi 23 ...
