Tecnosystemi Smart Clima Ultrasound Clean Machine, User Manual

Accessories for

                       Air Conditioning

     Ventilation

                        Solutions 

Air Curtains and

                       Accessories

 Accessories

                     For Heating

Instruments &

                         Tools

Multi - Zone

Air Control System

12

PREPARATING

1. Connect 

Ultrasound 

Clean Machine

 to the power 

supply

2. Pour inside the nebulizer 

the liquid. Use the 

liquid recommended by 

Tecnosystemi.

3. Connect the specific 

conveyor tube to 

Ultrasound Clean Machine.

DIRECTIONS CONTROL PANEL

1. After pouring one dose of the liquid, the two READY/ON green leds start to flash.

2. In case too much liquid is poured inside 

Ultrasound Clean Machine

 and maximum level is 

exceeded, HIGH LEVEL red led will start flashing (warning for excess) and nebulisation will 

be blocked.

3. Pressing START/STOP button 100 ml (in case you use the dose of 120 ml) or START/STOP 

button 200 ml (in case you use the dose of 220 ml), the device is automatically set on a 

minimum operating time of 11 minutes.

4. When 

Ultrasound Clean Machine

 starts nebulising the READY/ON green led stops flashing 

and stays fixed.

5. If the internal temperature reaches more than 65°C the device stops nebulising and the HIGH 

TEMPERATURE red led switches on (warning of high temperature), but the fan will keep 

working.

6. Nebulisation will restart when the temperature will recover under 60°C and the HIGH 

TEMPERATURE red led will switch off.

START/STOP

button

HIGH TEMPERATURE

red led

READY/ON

green led

HIGH LEVEL

red led