ENGLISH
User’s manual
4
ATA Energy Storage System MM
3
Receipt and site selection
Carefully remove the ATA from its packaging, and carry out a meticulous inspection. We recommend keeping the
original packaging in a secure place, in case you need to send the ATA for maintenance purposes. In case of transport
damage, notify the carrier and dealer immediately.
We recommend paying attention to the below points in order to choose a correct placement for your ATA:
The electrical installation has to be done by qualified personnel.
ATTENTION: be careful to place the ATA on a surface that is able to withstand the
mechanical characteristics (size and weight) specified in the chapter "Technical
Specifications".
ATTENTION: be careful in using a fixing system suitable to the mounting surface and to
the weight of ATA.
TECNOWARE declines any responsibility if these warnings are disregarded.
1.
The ATA is designed to operate in a protected environment. We therefore recommend installing it in a place
with very little or no humidity, dust or smoke.
2.
When the ATA is brought from a cold place to a warmer place, humidity in the air may cause condensation in
the ATA. In this case, allow ATA to stand for two hours in the warmer place before beginning with the
installation.
3.
In all circumstances, see the “Technical Characteristics” chapter for environmental specifications and check
that the selected area meets these criteria.
4.
During normal operation the ATA discharges a minimal amount of heat. So it is necessary to leave at least 20
cm of unobstructed space on the side and 50 cm up and down of ATA in order to keep it properly ventilated.
Summary of Contents for ATA 4.0 MM
Page 2: ......
Page 64: ...ENGLISH User s manual 58 ATA Energy Storage System MM...
Page 123: ......
Page 124: ...TECNOWARE s r l www tecnoware com...
