UPS ECO STRIP 0.50 – 0.70 – 0.90 – 1.1 - 1.3
11
User’s manual
9
Maintenance
9.1
UPS Cleaning
Before starting any cleaning operation, be sure that:
1.
The AC Input Voltage for the UPS has been removed.
2.
The UPS is OFF.
Use only a cloth dampened with water to clean the unit.
If UPS works in an environmental unusually dusty or dirty, remove the dirty from the ventilation holes.
Before restarting the UPS be sure it is completely dry. If any liquid gets inside the UPS, do not start the unit and
contact Technical Service immediately.
9.2
Battery
If the UPS is NOT going to be used for a long period of time, ensure that the batteries are left fully charged.
If the UPS has not been used for more than three months, go through the “First Start Up” procedure described in
the chapter 5 before using it again.
Please keep in mind that the batteries must be recharged at least once a month. Take in mind that batteries are
recharged automatically if the UPS works in Normal mode or if the UPS is off and connected to the AC Input Line.
Battery life strongly depends on the ambient temperature. There are also other factors like the number of charge-
discharge cycles, the discharge depth, humidity and altitude.
The recommended environmental specifications for a correct use of batteries are listed in the “Technical
Specifications” section.
9.3
Battery Replacement
Battery replacement must be performed exclusively by qualified and authorized technical personnel. We advise
you to follow the steps below explained for greater safety:
1.
Turn the UPS off and disconnect the AC Input Line for the UPS.
2.
Unscrew the 4 screws on the UPS bottom side. Remove the case cover and so you can access to the battery
location.
3.
Disconnect the battery wires and gently extract the battery from the case.
4.
The new battery must be exactly the same type as the original one.
5.
Put inside the new battery and connect it as the original one.
6.
Reassemble the case cover.
Summary of Contents for ECO STRIP 0.50
Page 2: ......
