ENGLISH
UPS EVO DSP MM Rack Tower
11
User’s manual
5.1.3 Acoustic Alarm
UPS status
Acoustic Alarm
OFF
Battery Mode
Beeping once every 4 seconds
YES
Low Battery
Beeping once every second
NO
Overload
Beeping twice every second
Fault Mode
Beeping continuously
Bypass Mode
Beeping once every 10 seconds
Note:
OFF = YES
: means that the buzzer can be muted or stopped, by pressing
ON/MUTE
button.
OFF = NO
: means that the buzzer can NOT be muted or stopped
5.2
Rear Side
Figure 4 – Rear Side
1.
Computer Interface (DB9 female connector
)
:
it is the communication RS-232 port.
2.
Computer Interface (USB connector
)
:
it is the communication USB port.
3.
Telephone Protection (RJ11/RJ45 IN/OUT connectors):
to protect and filter a phone line, an ADSL or a LAN
.
4.
EPO (Emergency Power OFF) connector
5.
Input Circuit Breaker:
it goes off in Overload or short-circuit condition; push the external button of the
Circuit Breaker to reactivate it.
6.
Grounded AC Input power socket:
IEC C14 (EVO DSP MM 1.3 Rack Tower) and IEC C20 (EVO DSP MM 2.6-4.0
Rack Tower) type to connect the UPS to the AC utility line by the included power cord.
7.
Grounded Output Receptacles:
IEC C13 type to supply loads.
8.
Slot for SNMP Interface (optional)
9.
Battery Box Connector:
remove the metal cover to access to the Battery Box Connector and to connect the
UPS to an external Battery Box.
10.
Grounded Output Power Receptacle:
IEC C19 type; For connecting an Output power line to supply all the
devices to be protected.
EVO DSP MM 1.3 Rack Tower
EVO DSP MM 2.6 Rack Tower
EVO DSP MM 4.0 Rack Tower
