________________________________________________________________________________
EVO STAR 60-800
43
INSTALLATION OF REMOTE PANEL WITHOUT E.P.O.
To install this board please follows the procedures below:
Make sure that the U.P.S. is off and that all the switches are off (if the U.P.S. is already operative please proceed to by-
pass setting chapter 5)
Unscrew the set screws from the second access panel of the U.P.S. and remove it.
Check if there is an interface board (picture 20); (present only if requested before purchase). Its position varies
according to the different models but it is always viewable and accessible by the user.
If there is a board please go directly over, otherwise continue with the following procedures.
Insert the four supports for the printed circuit in the holes
Fasten the board as specified in picture , to the supports you have just inserted
Create a connection with the supplied flat-cable between connector A and connector CN3 on the relay board ,
respecting polarity, that is to say, the coloured wire level with the sign on the board
1
14
B
A
Picture 10.2
Picture 10.3