12
Wind
※
Turbine Assemble
Procedure:
(1) Fasten the three blades into the circular hub using two 12mm-diameter, 63mm-long bolts
(6)
for
each blade. To refer Figure 4, firstly put one spring washer
(9)
through the bolt, follow by one flat
washer
(8)
, insert them through the blade, stainless steel plate
(14)
and hub, put another spring
washer
(9)
through the protruding part of the bolt, apply Loctite to the thread, and fasten with a
nut
(7)
. Press the spinner into the hub.
Figure 4 Assembly of blades and spinner
(2) Attach the tail assembly to the central body assembly using two 8mm-diameter bolts
(10)
. To refer
Figure 5, firstly put one flat washer
(8)
through the bolt
(10)
, insert them through the tail and
nacelle, put another flat washer
(8)
to the bolt, apply Loctite to the thread, and fasten with a
nut
(11)
.
(3) Attach the wind turbine power output wires to the power cable with insulated heat shrunk tube
and straighten the cable. Put the supporting pole into the tower mount adapter using two
12mm-diameter, 130mm-long bolts
(13)
. To refer Figure 6, firstly put one flat washer
(8)
through
the bolt
(13)
, insert them through the adapter and pole, put another flat washer
(8)
to the bolt
(13)
,
apply Loctite to the thread, and fasten with two nuts
(7)
.
(Notice! Don’t PRESS or DISTORY
wires when assemble supporting pole)
6
3
8 9
7
9
14
