TECO Seachill TR30 Installation Manual Download

Page: 7 / 7

HEATER INSTALLATION GUIDE

STEP 4

Plug in and turn on the chiller

Find the circuit board on the top of the electronic housing.

Remove the plastic “jumper” from prongs 4 and 5 (See
Diagram Below).

Place jumper on pins 7&8, this will reset your chiller.

Remove jumper from pins 7&8.

Now turn off your chiller.

CAUTION: Leaving chiller on with no water flowing will

cause the unit to overheat.

Place Jumper over pins 5&6

Note: Resting your chiller will change your set temperature

to the default of 77.

Re-connect the green ground cable, replace housing. Your

Chiller’s heater is now installed.

No Heater or UV

Heater and UV Installed

Heater Installed

UV Installed

Heater

Jumper

Reset

Jumper

Summary of Contents for Seachill TR30

Page 1: ...SUPPLEMENTAL INSTRUCTIONS FOR TR30 TR60 HEATER INSTALLATION GUIDE ...

Page 3: ...Contact Us North American distributor TECO US Service service tecous com Sales sales tecous com www tecous com ...

Page 4: ...de housing about 2 8 20cm back Unplug green ground wire from housing Slide the 3 housing off Keep the plastic washers that come with the housing screws these prevent chipping of the housing powder coat Slide Housing completely off 4 Do not operate the chiller until housing is replaced STEP 1 ...

Page 6: ...EATER INSTALLATION GUIDE STEP 3 Pull the heater plug through the hole in the frame 1 Connect two pin adapter on wiring harness to one of 2 the available two pin connectors mounted on top of support strut ...