1
2
3
4
5
6
7
8
•
Plug in and
turn on
the chiller
•
At the top of the control panel, above the display and
controls are a series of small metal prongs. Remove
the plastic ‘jumper’ from prongs 1-2 or 4-5.
•
Place jumper on pins 7-8 momentarily.
•
Remove jumper from pins 7-8.
•
Replace the jumper to its original location.
•
Now
turn off
your chiller.
Note: Resetting your chiller will change your set
temperature back to the default of 23°C.
CAUTION: Leaving chiller on for extended periods of time with
no water flowing will cause the unit to overheat.
UV Jumper
(Position may vary depending on whether UV is installed
- shown in the “no UV position”)
Heater Jumper
(Position may vary depending on whether heater is installed
- shown in the “no Heater position”)
Resit Pins
(
Place jumper here
momentarily to Reset
)
S
tep
3
Resetting Chiller
Fro
nt
of
Chi
ller