TECO TD-12M1, User Manual

7

CONTROL PANEL

FULL

DEFROST

DEHUMIDIFYING

CONT.

LOW

HIGH

OFF

MED.

TD12M1

Fig. 5

Defrost LED (1)

Full LED (2)

Dehumidifying 
LED (3)

Control 
Knob (4)

Panel Function Description



Defrost LED (1)

To prevent damage to the dehumidifi er, it will automatically detect if defrosting is required. The 

compressor will stop and the DEFROST light will be displayed.  The defrost cycle will begin and 

continue until the dehumidifi er is completely defrosted. The dehumidifi er will resume normal 

operation after it completes defrosting.



Full LED (2)

When the water tank is full, the buzzer will sound and the FULL light will remain on. Remove 

the water tank and dispose of the water. Replace the water tank and the dehumidifi er will resume 

operating automatically once the tank is correctly inserted.



Dehumidifying LED (3)

The DEHUMIDIFYING LED indicates when the dehumidifi er is functioning and the compressor is 

running. This light goes out when the appliance cycles off  when the selected humidity level has been 

met or  the power is off .



Control Knob (4)

The Control Knob (4) is used to select a relative humidity level, to set continuous dehumidifying or to 

 turn 

off  the appliance.

Operating Instructions

Note

: Before use, ensure the Control Knob (4) is in the OFF position.



Plug in the power cord to a mains socket and switch on the power.



Turn the Control Knob (4) to the desired humidity level or to continuous mode (CONT.).



If the ambient relative humidity is lower than the selected humidity of the dehumidifi er, the 

     dehumidifi er will cycle off . Once the ambient relative humidity rises above the selected point, the 

     dehumidifi er will automatically cycle on and continue to retain the selected humidity level.

Turning off  the dehumidifi er



Turn the Control Knob (4) to the OFF position.