TECO Chiller
TECO Chiller
Safety Precautions
Attention!
THIS PRODUCT IS NOT SUITABLE FOR CHILDREN BELOW SIX YEARS.
Children should be supervised to ensure that they do not play with the appliance.
This appliance is not intended for use by person (including children) with reduced phisical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the appliance by a person
responsible for their
safety.
NOTE : KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCES.
NOTE : KEEP THE PACKING FOR FUTURE TRANSPORTS.
General
1) Before install the chiller,
please confirm the local power supply is in accordance with
the requirement of the chiller,
refer to the Technical data and the Wiring diagram
provided in the manual.
2)
Connecting the chiller to a ground wire is necessary, in order to prevent electrical
shock caused by an unexpected short circuit inside the unit.
3)
Please install the electrical protection devices, according to the local regulations.
4)
The chiller must be installed on reliable base or supporting framework.
5)
If the chiller is installed on the loor, its base or supporting framework should be
heightened,to avoid ingression of accumulated water in rainy reason. In snowy areas,
it is important to prevent accumulated snow from blocking up the air-out. The
recommended height is 20cm to 30cm.
6)
Install the drainage pipe before fix the chiller to the ground. There are two drainage
hole on the chiller base, which could be connected to the drainage pipe with a pipe
arches which contains in spare parts.
7)
Drain ditch or other facilities should be arranged under the chiller, to avoid the
environment influence because of water discharge.
8)
Ensure the unit is
well
ventilated
,
direction
of
air
exhaust
is
kept
away
from
windows of
neighboring
buildings
,
and
the
exhaust
air
cannot
flow
back
.
Moreover
,
adequate service
clearance should be kept around the unit.
9)
DO NOT put fingers or sticks into the ventilative fan.
10)
The unit should not be installed at places accompanied with oil, inflammable gas,
corrosive components e.g. sulfur compound, or high-frequency equipment.
11)
The chiller is usually placed next to a house, which gives a directed sound
distribution that should
be considered, so it should take proper action to reduce the
noise impact.
Introduction
1) Chiller in this manual are designed for heating and cooling water within 5
to 40
℃
.
℃
2) It is suitable for fresh water and salt water at the ambient temperature from 5
to 35
℃
.
℃
1
