3.3.3 Initialise the printer.
Initialise will recover the default settings and remove user files in DRAM. Please run it
carefully.
Default settings in the below table
Setting
Default value
Speed
152.0 mm/sec (6 ips) (203DPI)
Density
8
Paper Width
3” (76 mm)
Paper High
5.11” (130 mm)
Sensor Kind
Gap sensor
Gap
0.16” (4.0 mm)
Direction
0
Start Point
0,0 (upper left corner)
Offset
0
Tear-Off Mode
On
Character Set
850
Country Code
001
Clean Flash
No
3.3.4 Skip to load AUTO.BAS
When turning on the printer, the AUTO.BAS file in the flash will be loaded and the
commands in this file will be automatically executed. To skip this process, please keep
pressing down the FEED key until the LED light become blue while turning on the printer.
