ENGLISH using TecraM1online.dot –– Printed on 24.02.2003 as 02_200UK
Optional Devices
8-13
Tecra M1
11. Seat the insulation sheet to cover the module.
Be sure to check that the insulation sheet is returned to the original
position to cover the memory module.
12. Insert two tabs of the keyboard into the slits of the computer case and
seat the keyboard at the original position. Fix it with three screws
removed in 6.
Be sure to use all screws that were removed in 6 and do not leave foreign
matters such as adhesive tape used in 9 or screws removed and dropped
in the computer.
13. Seat the keyboard brace in the original position.
14. Replace the battery pack as described in Chapter 6,
Power and
Power-up Modes
.
15. Turn the power on and make sure the added memory is recognized.
Open
System Properties
in the Control Panel and click the
General
tab.
Removing memory module
To remove the memory module, make sure the computer is in boot mode
then:
1. Be sure the power is off and all cables are disconnected from the
computer.
2. Turn the computer upside down and remove the battery.
3. Follow the instructions 4 through 9 in “Installing memory module” to
appear memory module.
4. Push the latches to the outside to release the module. A spring will
force one end of the module up.
5. Pinch the module by the sides and pull it out.
1. If you use the computer for a long time, the memory modules and the
circuits locating close to the memory modules will become hot. In this
case, let them cool to room temperature before you replace them. Or
you will get burnt if you touch any of them.
2. Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.
