P. 6
Tecshow Mini UV Bar |
English version
DMX address setting
Each fixture must set a specific starting address.
When receiving signal transmission, fixture will
receive channel control signals which from the
starting address.
According to different requirements or easy to use,
the user can set many value fixtures to the same
address, also can set up a separate address for
every device.
If you set the same address,all the devices will
receive from DMX channels signal. All connecting
fixtures are jointly controlled, controller can't sepa-
rate control a device.
If you set a different address, each device will be
separate from its particular set the starting address
and begin accepting DMX512 control signal, so that
more convenient separate control one device. Using
this method must be based on channel quantity of
device to determine a starting address.
If led light has 2 channels.you should set the start-
ing address of the first unit to 1, the second unit to
3 (2+1), the third unit to 5 (4+1), and so on.
Light 1 : address 1
Light 2: address 12
Light 3: address 23
1. The applicable temperature for the lighting is
between -25°C to 40°C. Do not use the lighting
under or above the temperature.
2. The installation of the effect has to be built and
constructed in a way that it can hold 10 times
the weight for 1 hour without any harming
deformation.
3.
The installation must always be secured with a
secondary safety attachment, e.g. an appropri-
ate safety rope.Never stand directly below the
device when mounting, removing or servicing
the fixture.
4.
The operator has to make sure the safety re-
lating and machine technical installations are
5. RINGING
Mounting bracket
Hanging bracket
