Page
6
Chapter 2 - Assembly and Setup
Attach the Display Upright
Attach the display
upright (5) to the
base (1) using two
5/16” by 2” screws
(8) and washers (10)
as shown in Figure
2. Be sure the ribbon
cable goes through
the slot, as shown,
and the display
console backplate is
facing toward the
base. Finger tighten
the screws; you will
finish tightening
them with a wrench
later, after installing
the handrails.
Attach the Display Console to the Display Upright
Remove the display console from the configuration kit. Attach the display ribbon cable from the
display upright to the connector on the back of the console. Make sure it fastens securely.
Attach the display console to the console backplate using four of the #10 Phillips-head screws.
Figure 2 - Attaching the Display Upright
