Page
8
Chapter 2 - Assembly and Setup
Plug in the Display Cable
Lay the Personal Climber on its right side. Take the lower end of the display ribbon cable (the one
you routed through the slot in the base when attaching the display upright). Fold around the motor
and plug it into the connector on the power board.
Leveling the Personal Climber
Move the climber to where you’ll use it. Press on either side of the front foot to see if you can rock
it from side to side. If you can, or if it is not level, raise or lower the glides on the front foot until
the climber is stable. Then, tighten the lock nuts on the front foot.
Plugging in the Personal Climber
The Personal Climber has both power in and power out sockets. You can plug a Personal Climber
into either a wall outlet or the power out socket on another Personal Climber. Using the correct
cord, plug one end into the “in” socket and the other end into the wall or another Personal Climber.
If you have daisy-chain power cords, you can connect up to 10 climbers using the same 10 amp
outlet.
Setting Options
Personal Climber offers an easy-to-access setup menu to let you match the climber’s display and
options to your needs. To set the options:
1.
Enter Setup Mode by turning the climber off, then holding down the
Switch Display
key
while turning it back on.
2.
For each of the following settings, use the up and down arrows to choose the value you
want, then press
Enter
to move on to the next option.
•
Full Setup or Step and Go: If you choose “Step and Go,” you can get on the
Personal Climber and start climbing, without entering any workout information. The
default is “Full Setup.”
When you choose “step and go” operation, the Personal Climber
automatically uses the settings from your last workout. You can override
these with new choices if you want.
•
Beep On or Off: Should the console keys beep when pressed? Choose On or Off.
•
USA Readout or International (“Intl”): The USA readout uses feet for distance and
pounds for weight. The International readout uses meters and kilos.
3.
When you’re done setting options, press the
Clear
key twice to save your settings and
leave setup mode.
If you decide not to change the settings, turn the climber off without leaving setup mode.
All settings keep their previous values.