CHAPTER 2 - ASSEMBLY AND SETUP
This chapter describes how to unpack and assemble your Personal Climber, and how to use setup
mode to configure the climber for your situation.
Assembly Overview
It’s easy to assemble the Personal Climber—it will probably take about 30 minutes. You need
these common tools:
•
3/16” Allen Wrench
•
7/16” wrench or socket wrench and ratchet
•
1/2” wrench
Here’s an overview of the steps in the assembly:
1.
Unpack the Personal Climber and make sure you have all the parts.
2.
Follow the detailed instructions to assemble the Personal Climber.
3.
Place the Personal Climber where it will be used and level it.
4.
Plug in the power cord.
Unpacking the Personal Climber
Use the 7/16”or ½” socket or wrench to remove the clamps and screws or tie straps holding the
chassis base to the pallet. Remove all parts from the shipping carton. Make sure you have all the
parts by checking against the parts list.
CAUTION: Do not stand the display console upright tube on its end!
Lay it flat instead.
Standing it on end could damage the display ribbon cable.
Parts List
Your Personal Climber includes these parts:
Description
Qty
Part Number
Item #
Base Unit
1
70310W or 70310B
1
Left Foot Assembly
1
70056
2
Right Foot Assembly
1
70057
3
Front Foot Assembly
1
70058
4
Display Upright Assembly
1
70360
5
Left Handrail
1
61089 or 61119
6
Right Handrail
1
61090 or 61120
7
Configuration Kit
1
varies by country
--
Hardware Kit
1
70362
--
