12/46
366473_a/ 03.2018
Installation Instructions
Translated from the original instructions |
■
■
5.1.■Condenser
The condenser and the condensing unit should be cleaned at
least once a year. Access from the inside of the unit can be
gained by removing the fan cover.
■
■
5.2.■Replacing■the■fan
- Switch off and isolate the condensing unit.
- Disconnect the fan motor cable from the junction box.
- Undo the 4 mounting bolts.
- Take off the fan motor assembly.
- Replace the motor-driven fan and its capacitor (size S model).
REMOVAL OF COVER
REFITTING COVER
■
5.3.■Replacing■the■compressor
In the case of a replacement of a compressor AJ²,
refer to
Appendix 6.
■
■
5.4.■Leak■checking■and■periodical■inspections
Use the appropriate equipment to empty or refill the system
(recovery machine, goggles, gloves etc.).
A leak detection check must be carried out according to the
local regulations or at least once a year.
■
■
5.5.■Electrical■checks
Systematically check the tightening of all screwed electrical
components.
Check regularly:
- Safety and control devices,
- The condition of electrical and refrigeration connections
(e.g. for any loosening or oxidation),
- Operating conditions,
- The mounting of the condensing unit on its base,
- The housing fixings (no vibration),
- Crankcase heater operation.
■
■
5.6.■Filter■drier
Silensys® condensing units are all fitted with a brazed filter
drier.
Replacement■filter■drier■selection:
When changing the filter drier, ensure that it is replaced with
an equivalent in capacity and pressure drop and with the
correct direction of flow.
6- WARRANTY
For information concerning the condensing unit warranty,
please refer to our general terms and conditions of sale.
7- DECLARATION OF CONFORMITY
Silensys® condensing units comply with the Low Voltage
Directive 2014/35/UE.
Silensys® condensing units are evaluated, designed,
constructed and documented as a sub-assembly compatible
with the recommendations of the Pressure Equipment
Directive 2014/68/EU and can be incorporated in an
assembly.
8- DECLARATION OF INCORPORATION
Only qualified staff are authorized to work on the condensing
unit. This product is defined as for installation in machines
according to European Directive 2006/42/CE.
It is not permitted to run the condensing unit before the
machine into which it is incorporated has been declared in
conformance with the pertaining legislation. The condensing
unit itself is therefore not required to comply with Directive
2006/42/CE.
In its constant endeavor to improve its products, TECUMSEH
EUROPE SALES AND LOGISTICS S.A.S.
S.A. reserves the right to change any information in this
instruction manual without prior notification.
Silensys® and L’Unite Hermétique® are registered trademarks
of TECUMSEH EUROPE S.A.S.
