2
3
Mode1: 2.G Wireless Mode:
This mode is enabled by default and the scanner
is paired with the receiver. No need to do any
further pairing, just plug and go.
I. Insert the 2.4G USB Adapter into the USB
port of computer.
II. Short press the trigger to turn on the scanner
III. Open a txt or excel on your PC and place
the cursor at the place where you want the
scanned data to go, Scanning results can be
displayed on computer then.
Mode2: USB wired Mode:
I. Connect TMCT-80 with computer via USB
cable
II. Short press the trigger to turn on the scanner
III. Open a txt or excel on your PC and place
the cursor at the place where you want the
scanned data to go, Scanning results can be
displayed on computer then.
Mode3: BLE Wireless Bluetooth Transmission
(This mode was disabled by default.)
TMCT-80 only supports Bluetooth 4.0 BLE
keyboard transmission mode, mainly apply to
Android phone, tablet, win10 Bluetooth
4.0 adapter data transmission.
NOTE: It cannot be paired with old Bluetooth 2.0
device via Bluetooth. Please make sure that your
device is Bluetooth 4.0 before pairing.
STEP 1: Enable BLE wireless mode
Scan “Enter Setup” - “Enable BLE” - “Exit & Save”
to enable BLE Wireless Bluetooth transmission.
